Reference Guide

Column Meaning
Name The view name for this entry.
OID Tree The OID tree that this entry will include or exclude.
Type Indicates if this entry includes or excludes the OID tree.
show trapflags
This command displays trap conditions. The command’s display shows all the enabled OSPFv2 and
OSPFv3 (Open Shortest Path First version 3) trapflags. Configure which traps the switch should
generate by enabling or disabling the trap condition. If a trap condition is enabled and the condition is
detected, the SNMP agent on the switch sends the trap to all enabled trap receivers. You do not have to
reboot the switch to implement the changes. Cold and warm start traps are always generated and
cannot be disabled.
Format show trapflags
Mode Privileged EXEC
Column Meaning
Authentication Flag Can be enabled or disabled. The factory default is enabled. Whether authentication failure
traps will be sent.
Link Up/Down Flag Can be enabled or disabled. The factory default is enabled. Whether link status traps will be
sent.
Multiple Users Flag Can be enabled or disabled. The factory default is enabled. Whether a trap will be sent when
the same user ID is logged into the switch more than once at the same time (either through
Telnet or the serial port).
Spanning Tree Flag Can be enabled or disabled. The factory default is enabled. Whether spanning tree traps are
sent.
ACL Traps May be enabled or disabled. The factory default is disabled. Whether ACL traps are sent.
BGP4 Traps Can be enabled or disabled. The factory default is disabled. Whether BGP4 traps are sent.
(This field appears only on systems with the BGPv4 software package installed.)
DVMRP Traps Can be enabled or disabled. The factory default is disabled. Whether DVMRP traps are sent.
OSPFv2 Traps Can be enabled or disabled. The factory default is disabled. Whether OSPF traps are sent. If
any of the OSPF trap flags are not enabled, then the command displays disabled.
Otherwise, the command shows all the enabled OSPF traps’ information.
OSPFv3 Traps Can be enabled or disabled. The factory default is disabled. Whether OSPF traps are sent. If
any of the OSPFv3 trap flags are not enabled, then the command displays disabled.
Otherwise, the command shows all the enabled OSPFv3 traps’ information.
PIM Traps Can be enabled or disabled. The factory default is disabled. Whether PIM traps are sent.
RADIUS Commands
This section describes the commands used to configure the switch to use a RADIUS server on your
network for authentication and accounting.
Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 107