Reference Guide

no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - that is, the RADIUS
accounting function is disabled.
Format no radius accounting mode
Mode Global Config
radius server attribute 4
This command specifies the RADIUS client to use the NAS-IP Address attribute in the RADIUS requests.
If the specific IP address is configured while enabling this attribute, the RADIUS client uses that IP
address while sending NAS-IP-Address attribute in RADIUS communication.
Format radius server attribute 4 [ipaddr]
Mode Global Config
Column Meaning
4 NAS-IP-Address attribute to be used in RADIUS requests.
ipaddr The IP address of the server.
no radius server attribute 4
The no version of this command disables the NAS-IP-Address attribute global parameter for RADIUS
client. When this parameter is disabled, the RADIUS client does not send the NAS-IP-Address attribute
in RADIUS requests.
Format
no radius server attribute 4 [ipaddr]
Mode Global Config
The following shows an example of the command.
(Extreme 220) (Config) #radius server attribute 4 192.168.37.60
(Extreme 220) (Config) #radius server attribute 4
radius server host
This command configures the IP address or DNS name to use for communicating with the RADIUS
server of a selected server type. While configuring the IP address or DNS name for the authenticating or
accounting servers, you can also configure the port number and server name. If the authenticating and
accounting servers are configured without a name, the command uses the
Default_RADIUS_Auth_Server and Default_RADIUS_Acct_Server as the default names, respectively.
The same name can be configured for more than one authenticating servers and the name should be
unique for accounting servers. The RADIUS client allows the configuration of a maximum 32
authenticating and accounting servers.
Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 112