Reference Guide

Parameter Description
retries The maximum number of transmission attempts in the range of 1 to 15.
no radius server retransmit
The no version of this command sets the value of this global parameter to the default value.
Format no radius server retransmit
Mode Global Config
radius source-interface
Use this command to specify the physical or logical interface to use as the RADIUS client source
interface (Source IP address). If configured, the address of source-interface is used for all RADIUS
communications between the RADIUS server and the RADIUS client. The selected source-interface IP
address is used for filling the IP header of RADIUS management protocol packets. This allows security
devices (firewalls) to identify the source packets coming from the specific switch.
If a source-interface is not specified, the primary IP address of the originating (outbound) interface is
used as the source address. If the configured interface is down, the RADIUS client falls back to its
default behavior.
Format
radius source-interface {unit/slot/port | loopback loopback-
id | vlan vlan-id}
Mode Global Config
Parameter Description
unit/slot/
port
The unit identifier assigned to the switch.
loopback-id
Configures the loopback interface. The range of the loopback ID is 0 to 7.
vlan-id
Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1
to 4093.
no radius source-interface
Use this command to reset the RADIUS source-interface to the default settings.
Format
no radius source-interface
Mode Global Config
Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 116