Reference Guide

boot host dhcp
Use this command to enable AutoInstall on the switch for the next reboot cycle. The command does not
change the current behavior of AutoInstall and saves the command to NVRAM.
Default enabled
Format boot host dhcp
Mode Privileged EXEC
no boot host dhcp
Use this command to disable AutoInstall for the next reboot cycle.
Format no boot host dhcp
Mode Privileged EXEC
boot host autosave
Use this command to automatically save the downloaded configuration file to the startup-config file on
the switch. When autosave is disabled, you must explicitly save the downloaded configuration to non-
volatile memory by using the write memory or copy system:running-config
nvram:startup-config command. If the switch reboots and the downloaded configuration has not
been saved, the AutoInstall process begins, if the feature is enabled.
Default
Disabled
Format boot host autosave
Mode Privileged EXEC
no boot host autosave
Use this command to disable automatically saving the downloaded configuration on the switch.
Format
no boot host autosave
Mode Privileged EXEC
boot host autoreboot
Use this command to allow the switch to automatically reboot after successfully downloading an image.
When auto reboot is enabled, no administrative action is required to activate the image and reload the
switch.
Default
Enabled
Format boot host autoreboot
Mode Privileged EXEC
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 136