Reference Guide

no boot host autoreboot
Use this command to prevent the switch from automatically rebooting after the image is downloaded
by using the AutoInstall feature.
Format no boot host autoreboot
Mode Privileged EXEC
erase startup-config
Use this command to erase the text-based configuration file stored in non-volatile memory. If the switch
boots and no startup-config file is found, the AutoInstall process automatically begins.
Format erase startup-config
Mode Privileged EXEC
erase factory-defaults
Use this command to erase the text-based factory-defaults file stored in non-volatile memory.
Default
Disabled
Format erase factory-defaults
Mode Privileged EXEC
show autoinstall
This command displays the current status of the AutoInstall process.
Format
show autoinstall
Mode Privileged EXEC
The following example shows CLI display output for the command.
(Extreme 220) #show autoinstall
AutoInstall Mode............................... Stopped
AutoInstall Persistent Mode.................... Disabled
AutoSave Mode.................................. Disabled
AutoReboot Mode................................ Enabled
AutoInstall Retry Count........................ 3
CLI Output Filtering Commands
In each of the following command descriptions, xxx represents any valid parameter for the show
command – for example, interface or running-config.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 137