Reference Guide

(Extreme 220) (Routing) #show port all | begin “1/1”
1/1 Enable Down Disable N/A N/A
1/2 Enable Down Disable N/A N/A
1/3 Enable Down Disable N/A N/A
1/4 Enable Down Disable N/A N/A
1/5 Enable Down Disable N/A N/A
1/6 Enable Down Disable N/A N/A
(Extreme 220) (Routing) #
show xxx|section “string”
The command is executed and the output is filtered to show only lines included within the section(s)
identified by lines containing the “string” match and ending with the first line containing the default
end-of-section identifier (that is, “exit”).
The following shows an example of this command.
(Extreme 220) (Routing) #show running-config | section “interface 0/1”
interface 0/1
no spanning-tree port mode
exit
show xxx|section “string” “string2”
The command is executed and the output is filtered to only show lines included within the section(s)
identified by lines containing the “string” match and ending with the first line containing the “string2”
match. If multiple sessions matching the specified string match criteria are part of the base output, then
all instances are displayed.
show xxx|section “string” include “string2”
The command is executed and the output is filtered to only show lines included within the section(s)
identified by lines containing the “string” match and ending with the first line containing the default
end-of-section identifier (that is, “exit”) and that include the “string2” match. This type of filter
command could also include “exclude” or user-defined end-of-section identifier parameters as well.
Dual Image Commands
Note
These commands are only available on selected Linux-based platforms.
The 200 Series software supports a dual image feature that allows the switch to have two software
images in the permanent storage. You can specify which image is the active image to be loaded in
subsequent reboots. This feature allows reduced downtime when you upgrade or downgrade the
software.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 139