Reference Guide

Table 7: CLI Command Modes (continued)
Command Mode Prompt Mode Description
Management
Access-list Config
Extreme nnn (config-macal)# Allows you to create a Management Access-List
and to enter the mode containing Management
Access-List configuration commands.
TACACS Config Extreme nnn (Tacacs)# Contains commands to configure properties for
the TACACS servers.
User-Group
Configuration
Mode
Extreme nnn (config-usergroup) Contains user group commands
Task-Group
Configuration
Mode
Extreme nnn (config-taskgroup) Contains task group commands
DHCP Pool Config Extreme nnn (Config dhcp-pool)# Contains the DHCP server IP address pool
configuration commands.
DHCPv6 Pool
Config
Extreme nnn (Config dhcp6-pool)# Contains the DHCPv6 server IPv6 address pool
configuration commands.
Stack Global
Config Mode
Extreme nnn (Config stack)# Allows you to access the Stack Global Config
Mode.
ARP Access-List
Config Mode
Extreme nnn (Config-arp-access-list)# Contains commands to add ARP ACL rules in an
ARP Access List.
Support Mode Extreme nnn (Support)# Allows access to the support commands, which
should only be used by the manufacturer's
technical support personnel as improper use
could cause unexpected system behavior and/or
invalidate product warranty.
Table 8 explains how to enter or exit each mode. To exit a mode and return to the previous mode, enter
exit. To exit to Privileged EXEC mode, press [Ctrl]+[Z].
Note
Pressing [Ctrl]+[Z] from Privileged EXEC mode exits to User EXEC mode. To exit User EXEC
mode, enter logout.
Table 8: CLI Mode Access and Exit
Command Mode Access Method
User EXEC This is the first level of access.
Privileged EXEC From the User EXEC mode, enter enable.
Global Config From the Privileged EXEC mode, enter configure.
VLAN Config From the Privileged EXEC mode, enter vlan database or vlan vlan_id.
Using the Command-Line Interface
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 16