Reference Guide

Parameter Description
unit/slot/
port
Clears forwarding database entries learned on for the specified interface.
macAddr
macMask
Clears dynamically learned forwarding database entries that match the range specified by
MAC address and MAC mask. When MAC mask is not entered, only specified MAC is removed
from the forwarding database table.
Box Services Commands
This section describes the Box Services commands. Box services are services that provide support for
features such as temperature, power supply status, fan control, and others. Each of these services is
platform dependent. (For example, some platforms may have temperature sensors, but no fan
controller. Or, others may have both while others have neither.)
Note
The bootloader version can only be supported on PowerPC platforms that use the u-boot
loader.
show version bootloader
Use this command to display Uboot version information.
Format
show version bootloader
Mode Privileged EXEC
The following example shows the output of the command:
(Extreme 220) #show version bootloader
Querying Active and Backup Software, please wait ....
Running Version................................ B1.0.0.5
Active Version................................. B1.0.0.5
Backup Version................................. B1.0.0.2
environment temprange
Use this command to set the allowed temperature range for normal operation.
Format
environment temprange min -100-100 max -100-100
Mode Global Config
Parameter Definition
min Sets the minimum allowed temperature for normal operation. The range is between
–100°C and 100°C. The default is 0°C.
max Sets the maximum allowed temperature for normal operation. The range is between
–100°C and 100°C. The default is 0°C.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 166