Reference Guide

Table 8: CLI Mode Access and Exit (continued)
Command Mode Access Method
Interface Config From the Global Config mode, enter:
interface unit/slot/port or
interface loopback id or
interface tunnel id
interface unit1/slot1/port1,unit2/slot2/port2,... (to
manage more than one interface)
interface unit1/slot1/port1-unit2/slot2/port2- (to manage
a range of interfaces)
interface vlan vlan-id
Interface LAG Config From the Global Config mode, enter interface lag lag-intf-num
Line Console From the Global Config mode, enter line console.
Line SSH From the Global Config mode, enter line ssh.
Line Telnet From the Global Config mode, enter line telnet.
AAA IAS User Config From the Global Config mode, enter aaa ias-user username name.
Mail Server Config From the Global Config mode, enter mail-server address
Policy-Map Config From the Global Config mode, enter policy-map.
Policy-Class-Map Config From the Policy Map mode enter class.
Class-Map Config From the Global Config mode, enter class-map, and specify the optional keyword
ipv4 to specify the Layer 3 protocol for this class. See class-map on page 599 for
more information.
Ipv6-Class-Map Config From the Global Config mode, enter class-map and specify the optional keyword
ipv6 to specify the Layer 3 protocol for this class. See class-map on page 599 for
more information.
Router RIP Config From the Global Config mode, enter router rip.
Route Map Config From the Global Config mode, enter -route-map map-tag.
IPv6 Address Family
Config
From the BGP Router Config mode, enter address-family ipv6.
Peer Template Config From the BGP Router Config mode, enter template peer name to create a BGP
peer template and enter Peer Template Configuration mode.
MAC Access-list Config From the Global Config mode, enter mac access-list extended name.
IPv4 Access-list Config From the Global Config mode, enter ip access-list name.
IPv6 Access-list Config From the Global Config mode, enter ipv6 access-list name.
Management Access-list
Config
From the Global Config mode, enter management access-list name.
TACACS Config From the Global Config mode, enter tacacs-server host ip-addr, where
ip-addr is the IP address of the TACACS server on your network.
User-Group Configuration
Mode
From the Global Config mode, enter the usergroup usergroup-name
command.
Using the Command-Line Interface
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 17