Reference Guide

Email Alerting and Mail Server Commands
logging email
This command enables email alerting and sets the lowest severity level for which log messages are
emailed. If you specify a severity level, log messages at or above this severity level, but below the urgent
severity level, are emailed in a non-urgent manner by collecting them together until the log time
expires.
Possible severity levels for logging messages are as follows. (You can enter either the word or the
corresponding numeral.)
•
emergency (0): The device is unusable.
•
alert (1): Action must be taken immediately.
•
critical (2): The device is experiencing primary system failures.
•
error (3): The device is experiencing non-urgent failures.
•
warning (4): The device is experiencing conditions that could lead to system errors if no action is
taken.
•
notice (5): The device is experiencing normal but significant conditions.
•
info (6): The device is providing non-critical information.
•
debug (7): The device is providing debug-level information.
Default
Disabled; when enabled, log messages at or above severity Warning (4) are emailed
Format logging email [severity-level]
Mode Global Config
no logging email
This command disables email alerting.
Format
no logging email
Mode Global Config
logging email urgent
This command sets the lowest severity level at which log messages are emailed immediately in a single
email message.
Possible severity levels for logging messages are as follows. (You can enter either the word or the
corresponding numeral.)
•
emergency (0): The device is unusable.
•
alert (1): Action must be taken immediately.
•
critical (2): The device is experiencing primary system failures.
•
error (3): The device is experiencing non-urgent failures.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 176