Reference Guide

Table Of Contents

clear mac access-list counters

This command clears the counters of the speciﬁed MAC ACL and MAC ACL rule.

Format clear mac access-list counters acl-name rule-id

Mode Privileged EXEC

clear pass

This command resets all user passwords to the factory defaults without powering o the switch. You are

prompted to conﬁrm that the password reset should proceed.

Format clear pass

Mode Privileged EXEC

clear traplog

This command clears the trap log.

Format clear traplog

Mode Privileged EXEC

clear vlan

This command resets VLAN conﬁguration parameters to the factory defaults. When the VLAN

conﬁguration is reset to the factory defaults, there are some scenarios regarding GVRP and MVRP that

happen due to this:

1 Static VLANs are deleted.

2 GVRP is restored to the factory default as a result of handling the VLAN RESTORE NOTIFY event.

Since GVRP is disabled by default, this means that GVRP should be disabled and all of its dynamic

VLANs should be deleted.

3 MVRP is restored to the factory default as a result of handling the VLAN RESTORE NOTIFY event.

Since MVRP is enabled by default, this means that any VLANs already created by MVRP are

unaected. However, for customer platforms where MVRP is disabled by default, then the MVRP

behavior should match GVRP. That is, MVRP is disabled and the MVRP VLANs are deleted.

Format

clear vlan

Mode Privileged EXEC

Utility Commands

ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 186