Reference Guide

poe power management
Use this command to set up the power management type.
Default Dynamic
Format poe power management {unit/slot/port | all} {dynamic |
static}
Mode Global Configuration
Parameter Description
unit Configures power management for an individual port.
all Configures power management for all ports.
dynamic Power management is done by the PoE controller and the maximum power for a
port is not reserved for each port.
static Power management is done by the PoE controller and maximum power for a port is
reserved.
no poe power management
Use this command to set the management mode to the default.
Format
no poe power management
Mode Global Configuration
poe priority
Use this command to configure the port priority level for the delivery of power to an attached device.
The switch may not be able to supply power to all connected devices, so the port priority is used to
determine which ports will supply power if adequate power capacity is not available for all enabled
ports. For ports that have the same priority level the lower-numbered port has higher priority.
For a system delivering peak power to a certain number of devices, if a new device is attached to a
high-priority port, power to a low-priority port is shut down and the new device is powered up.
Default
Low
Format poe priority { Crit | Hig | Low | Medium}
Mode Interface Configuration
no poe priority
Use this command to return the port priority level to the default value.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 197