Reference Guide

sntp client mode
This command enables SNTP client mode and may set the mode to either broadcast or unicast.
Default Disabled
Format sntp client mode [broadcast | unicast]
Mode Global Config
no sntp client mode
This command disables SNTP client mode.
Format no sntp client mode
Mode Global Config
sntp client port
This command sets the SNTP client port ID to 0, 123 or a value between 1025 and 65535. The default
value is 0, which means that the SNTP port is not configured by the user. In the default case, the actual
client port value used in SNTP packets is assigned by the underlying OS.
Default
0
Format sntp client port portid
Mode Global Config
no sntp client port
This command resets the SNTP client port back to its default value.
Format
no sntp client port
Mode Global Config
sntp unicast client poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a power of two where poll-
interval can be a value from 6 to 10.
Default
6
Format sntp unicast client poll-interval poll-interval
Mode Global Config
no sntp unicast client poll-interval
This command resets the poll interval for SNTP unicast clients to its default value.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 201