Reference Guide

2 Stacking Commands
Dedicated Port Stacking
Stack Port Commands
Stack Firmware Synchronization Commands
This chapter describes the stacking commands available in the 200 Series CLI.
Caution
The commands in this chapter are in one of two functional groups:
•
Show commands display switch settings, statistics, and other information.
•
Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
Note
The Primary Management Unit is the unit that controls the stack.
Note
Only 220 switches can be stacked.
Dedicated Port Stacking
This section describes the commands used to configure dedicated port stacking.
stack
This command sets the mode to Stack Global Config.
Format
stack
Mode Global Config
member
This command configures a switch. The unit is the switch identifier of the switch to be added/removed
from the stack. The switchindex is the index into the database of the supported switch types, indicating
the type of the switch being preconfigured. The switch index is a 32-bit integer. This command is
executed on the Primary Management Unit.
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 21