Reference Guide

Default None
Format dns-server address1 [address2....address8]
Mode DHCP Pool Config
no dns-server
This command removes the DNS Server list.
Format no dns-server
Mode DHCP Pool Config
hardware-address
This command specifies the hardware address of a DHCP client.
hardwareaddress is the MAC address of the client's hardware platform, consisting of six bytes in
dotted hexadecimal format.
Default ethernet
Format hardware-address hardwareaddress
Mode DHCP Pool Config
no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode DHCP Pool Config
host
This command specifies the IP address and network mask for a manual binding to a DHCP
client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP
address 0.0.0.0 is invalid. The prefix-length is an integer from 0 to 32.
Default
None
Format host address [{mask | prefix-length}]
Mode DHCP Pool Config
no host
This command removes the IP address of the DHCP client.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 211