Reference Guide

netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name servers that are
available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one command line.
Servers are listed in order of preference (address1 is the most preferred server, address2 is the next most
preferred server, and so on).
Default None
Format netbios-name-server address [address2...address8]
Mode DHCP Pool Config
no netbios-name-server
This command removes the NetBIOS name server list.
Format no netbios-name-server
Mode DHCP Pool Config
netbios-node-type
The command configures the NetBIOS node type for Microsoft DHCP clients. type Specifies the
NetBIOS node type. Valid types are:
•
b-node—Broadcast
•
p-node—Peer-to-peer
•
m-node—Mixed
•
h-node—Hybrid (recommended)
Default
None
Format netbios-node-type type
Mode DHCP Pool Config
no netbios-node-type
This command removes the NetBIOS node Type.
Format
no netbios-node-type
Mode DHCP Pool Config
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 214