Reference Guide

Column Meaning
Detection time The time when the conflict was found.
DNS Client Commands
These commands are used in the Domain Name System (DNS), an Internet directory service. DNS is
how domain names are translated into IP addresses. When enabled, the DNS client provides a hostname
lookup service to other components of 200 Series.
ip domain lookup
Use this command to enable the DNS client.
Default Enabled
Format ip domain lookup
Mode Global Config
no ip domain lookup
Use this command to disable the DNS client.
Format
no ip domain lookup
Mode Global Config
ip domain name
Use this command to define a default domain name that 200 Series software uses to complete
unqualified host names (names with a domain name). By default, no default domain name is configured
in the system. name may not be longer than 255 characters and should not include an initial period. This
name should be used only when the default domain name list, configured using the ip domain list
command, is empty.
Default
None
Format ip domain name name
Mode Global Config
The CLI command ip domain name yahoo.com will configure yahoo.com as a default domain name. For
an unqualified hostname xxx, a DNS query is made to find the IP address corresponding to
xxx.yahoo.com.
no ip domain name
Use this command to remove the default domain name configured using the ip domain name
command.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 221