Reference Guide

Format no ip domain name
Mode Global Config
ip domain list
Use this command to define a list of default domain names to complete unqualified names. By default,
the list is empty. Each name must be no more than 256 characters, and should not include an initial
period. The default domain name, configured using the ip domain name command, is used only when
the default domain name list is empty. A maximum of 32 names can be entered in to this list.
Default None
Format ip domain list name
Mode Global Config
no ip domain list
Use this command to delete a name from a list.
Format no ip domain list name
Mode Global Config
ip name server
Use this command to configure the available name servers. Up to eight servers can be defined in one
command or by using multiple commands. The parameter server-address is a valid IPv4 or IPv6 address
of the server. The preference of the servers is determined by the order they were entered.
Format
ip name-server server-address1 [server-address2...server-
address8]
Mode Global Config
no ip name server
Use this command to remove a name server.
Format
no ip name-server [server-address1...server-address8]
Mode Global Config
ip name source-interface
Use this command to specify the physical or logical interface to use as the DNS client (IP name) source
interface (source IP address) for the DNS client management application. If configured, the address of
source Interface is used for all DNS communications between the DNS server and the DNS client. The
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 222