Reference Guide

The following example shows CLI display output for the command.
(Extreme 220) # show hosts
Host name......................... Device
Default domain.................... gm.com
Default domain list............... yahoo.com, Stanford.edu, rediff.com
Domain Name lookup................ Enabled
Number of retries................. 5
Retry timeout period.............. 1500
Name servers (Preference order)... 176.16.1.18 176.16.1.19
DNS Client Source Interface....... (not configured)
Configured host name-to-address mapping:
Host Addresses
------------------------------ ------------------------------
accounting.gm.com 176.16.8.8
Host Total Elapsed Type
Addresses
--------------- -------- ------ -------- --------------
www.stanford.edu 72 3
IP 171.64.14.203
show ip name source-interface
Use this command to display the configured source interface details used for a DNS client. The IP
address of the selected interface is used as source IP for all communications with the server.
Format
show ip name source-interface
Mode Privileged EXEC
IP Address Conflict Commands
The commands in this section help troubleshoot IP address conflicts.
ip address-conflict-detect run
This command triggers the switch to run active address conflict detection by sending gratuitous ARP
packets for IPv4 addresses on the switch.
Format
ip address-conflict-detect run
Mode
•
Global Config
•
Virtual Router Config
show ip address-conflict
This command displays the status information corresponding to the last detected address conflict.
Format
show ip address-conflict
Modes Privileged EXEC
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 226