Reference Guide

movemanagement
This command moves the Primary Management Unit functionality from one switch to another. The
fromunit is the switch identifier on the current Primary Management Unit. The tounit is the switch
identifier on the new Primary Management Unit. Upon execution, the entire stack (including all
interfaces in the stack) is unconfigured and reconfigured with the configuration on the new Primary
Management Unit. After the reload is complete, all stack management capability must be performed on
the new Primary Management Unit. To preserve the current configuration across a stack move, execute
the copy system:running-config nvram:startup-config (in Privileged EXEC) command before performing
the stack move. A stack move causes all routes and layer 2 addresses to be lost. This command is
executed on the Primary Management Unit. The system prompts you to confirm the management
move.
Format movemanagement fromunit tounit
Mode Stack Global Config
standby
Use this command to configure a unit as a Standby Management Unit (STBY).
Note
The Standby Management Unit cannot be the current Management Unit.
Format standby unit number
Mode Stack Global Config
Parameter Description
unit number
The unit number which is to be the Standby Management Unit. Must be
a valid unit number.
no standby
The no form of this command allows the application to run the auto Standby Management Unit logic.
Format
no standby
Mode Stack Global Config
slot
This command configures a slot in the system. The unit/slot is the slot identifier of the slot. The
cardindex is the index into the database of the supported card types, indicating the type of the card
being preconfigured in the specified slot. The card index is a 32-bit integer. If a card is currently present
in the slot that is unconfigured, the configured information will be deleted and the slot will be
reconfigured with default information for the card.
Stacking Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 23