Reference Guide

set slot power
This command configures the power mode of the slot(s) and allows power to be supplied to a card
located in the slot. If you specify all, the command is applied to all slots, otherwise the command is
applied to the slot identified by unit/slot.
Use this command when installing or removing cards. If a card or other module is present in this slot,
the power mode is applied to the contents of the slot. If the slot is empty, the power mode is applied to
any card inserted into the slot.
Format set slot power [unit/slot] | all]
Mode Global Config
no set slot power
This command unconfigures the power mode of the slot(s) and prohibits power from being supplied to
a card located in the slot. If you specify all, the command prohibits power to all slots, otherwise the
command prohibits power to the slot identified by unit/slot.
Use this command when installing or removing cards. If a card or other module is present in this slot,
power is prohibited to the contents of the slot. If the slot is empty, power is prohibited to any card
inserted into the slot.
Format
no set slot power [unit/slot] | all]
Mode Global Config
reload (Stack)
This command resets the entire stack or the identified unit. The unit is the switch identifier. The system
prompts you to confirm that you want to reset the switch.
Format
reload [unit]
Mode Privileged EXEC
stack-status sample-mode
Use this command to configure global status management mode, sample size. The mode, sample size
parameters are applied globally on all units in the stack. The default sampling mode of the operation is
cumulative summing.
Note
This configuration command is implemented as part of serviceability functionality and
therefore is not expected to be persistent across reloads. This configuration is never visible in
the running configuration under any circumstances. It is the responsibility of the user to
switch the sample mode on-demand as per the requirement. This configuration is applied to
all the members that are part of the stack when the command is triggered. This configuration
cannot play onto cards that are part of the stack at later point of the time.
Stacking Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 25