Reference Guide

Column Meaning
Receiver Index The sFlow Receiver associated with the sampler/poller.
Owner String The identity string for receiver, the entity making use of this sFlowRcvrTable entry.
Time Out The time (in seconds) remaining before the receiver is released and stops sending samples to
sFlow receiver. The no timeout value of this parameter means that the sFlow receiver is
configured as a non-timeout entry.
Max Datagram Size The maximum number of bytes that can be sent in a single sFlow datagram.
Port The destination Layer4 UDP port for sFlow datagrams.
IP Address The sFlow receiver IP address.
Address Type The sFlow receiver IP address type. For an IPv4 address, the value is 1 and for an IPv6
address, the value is 2.
Datagram Version The sFlow protocol version to be used while sending samples to sFlow receiver.
The following example shows CLI display output for this command.
(Extreme 220) #show sflow receivers 1
Receiver Index................................. 1
Owner String................................... tulasi
Time out....................................... 0
IP Address:.................................... 0.0.0.0
Address Type................................... 1
Port........................................... 6343
Datagram Version............................... 5
Maximum Datagram Size.......................... 1400
The following examples show CLI display output for the command when a receiver is configured as a
non-timeout entry.
(Extreme 220) (Routing) #show sflow receivers
Rcvr Owner Timeout Max Dgram Port IP Address
Indx String Size
---- -------------------------------- ---------- --------- ----- ---------------
1 tulasi No Timeout 1400 6343 0.0.0.0
2 0 1400 6343 0.0.0.0
3 0 1400 6343 0.0.0.0
4 0 1400 6343 0.0.0.0
5 0 1400 6343 0.0.0.0
6 0 1400 6343 0.0.0.0
7 0 1400 6343 0.0.0.0
8 0 1400 6343 0.0.0.0
(Extreme 220) (Routing) #show sflow receivers 1
Receiver Index................................. 1
Owner String................................... tulasi
Time out....................................... No Timeout
IP Address:.................................... 0.0.0.0
Address Type................................... 1
Port........................................... 6343
Datagram Version............................... 5
Maximum Datagram Size.......................... 1400
show sflow source-interface
Use this command to display the sFlow source interface configured on the switch.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 250