Reference Guide

Format show sflow source-interface
Mode Privileged EXEC
Column Meaning
sFlow Client Source Interface The interface ID of the physical or logical interface configured as the sFlow
client source interface.
sFlow Client Source IPv4 Address The IP address of the interface configured as the sFlow client source interface.
The following example shows CLI display output for the command.
(Extreme 220) (Routing) #show sflow source-interface
sFlow Client Source Interface.................. (not configured)
Green Ethernet Commands
This section describes the commands used to configure Green Ethernet modes on the system to save
power. 200 Series software supports the following three Green Ethernet modes:
•
Energy-detect mode
•
Short-reach mode
•
Energy-ecient Ethernet (EEE) mode
Note
Support for each Green Ethernet mode is platform dependent. The features and
commands described in this section might not be available on your switch.
green-mode energy-detect
Use this command to enable energy-detect mode on an interface or on a range of interfaces. With this
mode enabled, when the port link is down, the port automatically powers down for short period of time
and then wakes up to check link pulses. In energy-detect mode, the port can perform auto-negotiation
and consume less power when no link partner is present.
Default
Disabled
Format green-mode energy-detect
Mode Interface Config
no green-mode energy-detect
Use this command to disable energy-detect mode on the interface(s).
Format
no green-mode energy-detect
Mode Interface Config
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 251