Reference Guide

green-mode eee
Use this command to enable EEE low-power idle mode on an interface or on a range of interfaces. The
EEE mode enables both send and receive sides of the link to disable some functionality for power
saving when lightly loaded. The transition to EEE low-power mode does not change the port link status.
Frames in transit are not dropped or corrupted in transition to and from this mode.
Default Disabled
Format green-mode eee
Mode Interface Config
no green-mode eee
Use this command to disable EEE mode on the interface(s).
Format no green-mode eee
Mode Interface Config
green-mode eee-lpi-history sampling-interval
Use this command to configure global EEE LPI (low-power idle) history collection interval for the
system. The value specified in this command is applied globally on all interfaces in the switch or stack of
switches. The sampling interval unit is seconds.
Note
The sampling interval takes eect immediately; the current and future samples are collected
at this new sampling interval.
Default 3600 seconds
Format green-mode eee-lpi-history sampling-interval 30–36000
Mode Global Config
no green-mode eee-lpi-history sampling-interval
Use this command to return the global EEE LPI history collection interval to the default value.
Format
no green-mode eee-lpi-history sampling-interval
Mode Global Config
green-mode eee-lpi-history max-samples
Use this command to configure global EEE LPI (low-power idle) history collection buer size for the
system. The value specified in this command is applied globally on all interfaces in the switch or stack of
switches.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 252