Reference Guide

Column Meaning
EEE Config EEE Admin Mode is enabled or disabled.
The following example shows CLI display output for a system that supports all Green Ethernet features.
(Extreme 220) (Routing) #show green-mode
Current Power Consumption (mW).............. 11172
Power Saving (%)............................ 10
Cumulative Energy Saving /Stack (W * H)... 10
Unit Green Ethernet Features Supported
---- --------------------------------
1 Energy-Detect Short-Reach EEE LPI-History LLDP-Cap-Exchg Pwr-Usg-Est
Interface Energy-Detect Short-Reach-Config Short-Reach EEE
Config Opr Auto Forced Opr Config
--------- --------- --------- --------- --------- ----------- --------
1/0/1 Enabled Active Enabled Disabled Inactive Enabled
1/0/2 Enabled Active Enabled Disabled Inactive Enabled
1/0/3 Enabled Active Enabled Disabled Inactive Enabled
1/0/4 Enabled Active Enabled Disabled Inactive Enabled
1/0/5 Enabled Active Enabled Disabled Inactive Enabled
1/0/6 Enabled Active Enabled Disabled Inactive Enabled
1/0/7 Enabled Active Enabled Disabled Inactive Enabled
--More-- or (q)uit
If you specify the port, the command displays the information in the following table.
Column Meaning
Energy-detect admin mode Energy-detect mode is enabled or disabled.
Energy-detect operational
status
Energy detect mode is currently active or inactive. The energy-detect mode may be
administratively enabled, but the operational status may be inactive. The possible
reasons for the status are described in the next field.
Reason for Energy-detect
current operational status
The energy detect mode may be administratively enabled, but the operational status
may be inactive for one of the following reasons:
•
Port is currently operating in the fiber mode.
•
Link is up.
•
Admin Mode is disabled.
If the energy-detect operational status is active, this field displays No
energy detected.
Short-reach auto Admin
mode
Short reach auto mode is enabled or disabled.
Short-reach force Admin
mode
Short reach force mode is enabled or disabled.
Short reach operational
status
Short reach mode is currently active or inactive. The short-reach mode may be
administratively enabled, but the operational status may be inactive.
Reason for Short Reach
current operational status
The short-reach mode may be administratively enabled, but the operational status
may be inactive for one of the following reasons:
•
Long cable >10m
•
Link down
•
Fiber
•
Admin Mode disabled
•
Not At GIG speed
•
Cable length unknown
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 254