Reference Guide

Parameter Description
event-number
An index that uniquely identifies an entry in the event table. Each such entry defines
one event that is to be generated when the appropriate conditions occur. The range
is 1 to 65535.
description string A comment describing the event entry. The default is alarmEvent.
log Specifies that an RMON log entry should be generated for this event.
ownerstring Owner string associated with the entry. The default is no owner string.
trap community The SNMP community specified by this octet string – used to send an SNMP trap.
The default is no community string.
The following shows an example of the command.
(Extreme 220) (Config) # rmon event 1 log description test
no rmon event
This command deletes the rmon event entry.
Format no rmon event event-number
Mode Global Config
The following shows an example of the command.
(Extreme 220) (Config) # no rmon event 1
rmon collection history
This command sets the history control parameters of the RMON historyControl MIB group.
Note
This command is not supported on interface range. Each RMON history control collection
entry can be configured on only one interface. If you try to configure on multiple interfaces,
DUT displays an error.
Format rmon collection history index-number [buckets number|
interval interval-in-sec| owner string]
Mode Interface Config
Parameter Description
index-number
An index that uniquely identifies an entry in the historyControl table. Each such
entry defines a set of samples at a particular interval for an interface on the device.
The range is 1 to 65535.
buckets number The maximum number of entries to maintain. The range is 1 to 65535. The default is
50.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 261