Reference Guide

Parameter Description
group id
ID or name of the group of statistics to apply on the interface. You can enter either
the word or the corresponding numeral. Valid values are:
•
1: received
•
2: received-errors
•
3: transmitted
•
4: transmitted-errors
•
5: received-transmitted
•
6: port-utilization
•
7: congestion
There is no default value.
time-range-name
Name of the time range for the group or the flow-based rule. The range is 1 to 31
alphanumeric characters. The default is None.
reporting-methods
Report the statistics to the configured method. Valid values are:
•
none
•
console
•
syslog
•
email
The default is none.
The following examples show how the command could be entered.
(Extreme 220) (Config) # stats group received timerange test reporting console email syslog
(Extreme 220) (Config) # stats group received-errors timerange test reporting email syslog
(Extreme 220) (Config) # stats group received-transmitted timerange test reporting none
no stats group
This command deletes the configured group.
Format
no stats group group id|name
Mode Global Config
The following example shows how the command could be entered.
(Extreme 220) (Config) # no stats group received
(Extreme 220) (Config) # no stats group received-errors
(Extreme 220) (Config) # no stats group received-transmitted
stats flow-based
This command configures flow based statistics rules for the given parameters over the specified time
range. Only an IPv4 address is allowed as source and destination IP address.
Utility Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 271