Reference Guide

If you do not supply a value for cardindex, the following output appears:
Column Meaning
Card Index (CID) The index into the database of the supported card types. This index is used when
preconfiguring a slot.
Card Model Identifier The model identifier for the supported card type.
If you supply a value for cardindex, the following output appears:
Column Meaning
Card Type The 32-bit numeric card type for the supported card.
Model Identifier The model identifier for the supported card type.
Card Description The description for the supported card type.
show switch
This command displays switch status information about all units in the stack or a single unit when you
specify the unit value.
Format show switch [unit]
Mode Privileged EXEC
Column Meaning
Switch The unit identifier assigned to the switch.
When you do not specify a value for unit, the following information appears:
Column
Meaning
Management Status Whether the switch is the Primary Management Unit, a stack member, a configured standby
switch, an operational standby switch, or the status is unassigned.
Preconfigured
Model Identifier
The model identifier of a preconfigured switch ready to join the stack. The Model Identifier is
a 32-character field assigned by the device manufacturer to identify the device.
Plugged-In Model
Identifier
The model identifier of the switch in the stack. Model Identifier is a 32-character field
assigned by the device manufacturer to identify the device.
Switch Status The switch status. Possible values for this state are: OK, Unsupported, Code Mismatch, SDM
Mismatch, Config Mismatch, or Not Present. A mismatch indicates that a stack unit is
running a dierent version of the code, SDM template, or configuration than the
management unit. The SDM Mismatch status indicates that the unit joined the stack, but is
running a dierent SDM template than the management unit. This status is temporary; the
stack unit should automatically reload using the template running on the stack manager.
If there is a Stacking Firmware Synchronization operation in progress status is
shown as Updating Code.
Code Version The detected version of code on this switch.
The following example shows CLI display output for the command.
(Extreme 220) (Config) #show switch
Management Standby Preconfig Plugged-in Switch Code
Stacking Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 28