Reference Guide

ManualsBrandsExtreme Networks ManualsSwitch200 Series

281

282

283

284

285

286

287

288

289

290

Table Of Contents

Column Meaning

Admin Mode The Port control administration state. The port must be enabled in order for it to be allowed into

the network. May be enabled or disabled. The factory default is enabled.

Physical Mode The desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex

mode and speed is set from the auto-negotiation process. Note that the maximum capability of

the port (full duplex -100M) is advertised. Otherwise, this object determines the port's duplex

mode and transmission rate. The factory default is Auto.

Physical Status The port speed and duplex mode.

Link Status The Link is up or down.

Link Trap This object determines whether to send a trap when link status changes. The factory default is

enabled.

LACP Mode LACP is enabled or disabled on this port.

The following command shows an example of the command output for all ports.

(Extreme 220) (Routing) #show port all

Admin Physical Physical Link Link LACP Actor

Intf Type Mode Mode Status Status Trap Mode Timeout

--------- ------ --------- ---------- ---------- ------ ------- ------ --------

0/1 Enable Auto 100 Full Up Enable Enable long

0/2 Enable Auto 100 Full Up Enable Enable long

0/3 Enable Auto Down Enable Enable long

0/4 Enable Auto 100 Full Up Enable Enable long

0/5 Enable Auto 100 Full Up Enable Enable long

0/6 Enable Auto 100 Full Up Enable Enable long

0/7 Enable Auto 100 Full Up Enable Enable long

0/8 Enable Auto 100 Full Up Enable Enable long

1/1 Enable Down Disable N/A N/A

1/2 Enable Down Disable N/A N/A

1/3 Enable Down Disable N/A N/A

1/4 Enable Down Disable N/A N/A

1/5 Enable Down Disable N/A N/A

1/6 Enable Down Disable N/A N/A

The following command shows an example of the command output for a range of ports.

(Extreme 220) (Routing) #show port 0/1-1/6