Reference Guide

no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the configuration
that this switch is currently using to the default value.
Format no spanning-tree configuration revision
Mode Global Config
spanning-tree cost
Use this command to configure the external path cost for port used by a MST instance. When the auto
keyword is used, the path cost from the port to the root bridge is automatically determined by the
speed of the interface. To configure the cost manually, specify a cost value from 1–200000000.
Default auto
Format spanning-tree cost {cost | auto}
Mode Interface Config
no spanning-tree cost
This command resets the auto-edge status of the port to the default value.
Format
no spanning-tree cost
Mode Interface Config
spanning-tree edgeport
This command specifies that an interface (or range of interfaces) is an Edge Port within the common
and internal spanning tree. This allows this port to transition to Forwarding State without delay.
Format
spanning-tree edgeport
Mode Interface Config
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal spanning
tree.
Format
no spanning-tree edgeport
Mode Interface Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 290