Reference Guide

switchport access vlan
Use this command to configure the VLAN on the Access port. Only one VLAN can be assigned to the
Access port. Access ports are members of VLAN 1 by default. Access ports may be assigned to a VLAN
other than VLAN 1. Removing the Access VLAN on the switch makes the Access port a member of
VLAN 1. Configuring an Access port to be a member of a VLAN that does not exist results in an error
and does not change the configuration.
Default 1 (Default VLAN)
Format switchport access vlan vlan-id
Mode Interface Config
no switchport access vlan
This command resets the switch port access mode VALN to its default value.
Format no switchport access vlan
Mode Interface Config
show interfaces switchport
Use this command to display the switchport status for all interfaces or a specified interface.
Format
show interfaces switchport unit/slot/port
Mode Privileged EXEC
(Extreme 220) (Routing) #show interfaces switchport 1/0/1
Port: 1/0/1
VLAN Membership Mode: General
Access Mode VLAN: 1 (default)
General Mode PVID: 1 (default)
General Mode Ingress Filtering: Disabled
General Mode Acceptable Frame Type: Admit all
General Mode Dynamically Added VLANs:
General Mode Untagged VLANs: 1
General Mode Tagged VLANs:
General Mode Forbidden VLANs:
Trunking Mode Native VLAN: 1 (default)
Trunking Mode Native VLAN tagging: Disable
Trunking Mode VLANs Enabled: All
Protected Port: False
#show interfaces switchport
Port: 1/0/1
VLAN Membership Mode: General
Access Mode VLAN: 1 (default)
General Mode PVID: 1 (default)
General Mode Ingress Filtering: Disabled
General Mode Acceptable Frame Type: Admit all
General Mode Dynamically Added VLANs:
General Mode Untagged VLANs: 1
General Mode Tagged VLANs:
General Mode Forbidden VLANs:
Trunking Mode Native VLAN: 1 (default)
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 335