Reference Guide

no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format no dot1x system-auth-control
Mode Global Config
dot1x system-auth-control monitor
Use this command to enable the 802.1X monitor mode on the switch. The purpose of Monitor mode is
to help troubleshoot port-based authentication configuration issues without disrupting network access
for hosts connected to the switch. In Monitor mode, a host is granted network access to an 802.1X-
enabled port even if it fails the authentication process. The results of the process are logged for
diagnostic purposes.
Default disabled
Format dot1x system-auth-control monitor
Mode Global Config
no dot1x system-auth-control monitor
This command disables the 802.1X Monitor mode on the switch.
Format
no dot1x system-auth-control monitor
Mode Global Config
dot1x user
This command adds the specified user to the list of users with access to the specified port or all ports.
The user parameter must be a configured user.
Format
dot1x user user {unit/slot/port | all}
Mode Global Config
no dot1x user
This command removes the user from the list of users with access to the specified port or all ports.
Format
no dot1x user user {unit/slot/port | all}
Mode Global Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 352