Reference Guide

Default None
Format storm-control broadcast action {shutdown | trap}
Mode
•
Global Config
•
Interface Config
no storm-control broadcast action
This command configures the broadcast storm recovery action option to the default value for all
interfaces (Global Config mode) or one or more interfaces (Interface Config mode).
Format no storm-control broadcast action
Mode
•
Global Config
•
Interface Config
storm-control broadcast level
Use this command to configure the broadcast storm recovery threshold for all interfaces (Global Config
mode) or one or more interfaces (Interface Config mode) as a percentage of link speed and enable
broadcast storm recovery. If the mode is enabled, broadcast storm recovery is active, and if the rate of
L2 broadcast trac ingressing on an interface increases beyond the configured threshold, the trac is
dropped. Therefore, the rate of broadcast trac is limited to the configured threshold.
Default
5
Format storm-control broadcast level 0-100
Mode
•
Global Config
•
Interface Config
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for all interfaces (Global
Config mode) or one or more interfaces (Interface Config mode) and disables broadcast storm recovery.
Format
no storm-control broadcast level
Mode
•
Global Config
•
Interface Config
storm-control broadcast rate
Use this command to configure the broadcast storm recovery threshold for all interfaces (Global Config
mode) or one or more interfaces (Interface Config mode) in packets per second. If the mode is enabled,
broadcast storm recovery is active, and if the rate of L2 broadcast trac ingressing on an interface
increases beyond the configured threshold, the trac is dropped. Therefore, the rate of broadcast trac
is limited to the configured threshold.
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 374