Reference Guide

Default 0
Format storm-control broadcast rate 0-33554431
Mode
•
Global Config
•
Interface Config
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces (Global
Config mode) or one or more interfaces (Interface Config mode) and disables broadcast storm recovery.
Format no storm-control broadcast rate
Mode
•
Global Config
•
Interface Config
storm-control multicast
This command enables multicast storm recovery mode for all interfaces (Global Config mode) or one or
more interfaces (Interface Config mode). If the mode is enabled, multicast storm recovery is active, and
if the rate of L2 multicast trac ingressing on an interface increases beyond the configured threshold,
the trac will be dropped. Therefore, the rate of multicast trac will be limited to the configured
threshold.
Default
Disabled
Format storm-control multicast
Mode
•
Global Config
•
Interface Config
no storm-control multicast
This command disables multicast storm recovery mode for all interfaces (Global Config mode) or one or
more interfaces (Interface Config mode).
Format
no storm-control multicast
Mode
•
Global Config
•
Interface Config
storm-control multicast action
This command configures the multicast storm recovery action to either shutdown or trap for all
interfaces (Global Config mode) or one or more interfaces (Interface Config mode). If configured to
shutdown, the interface that receives multicast packets at a rate above the threshold is diagnostically
disabled. The option trap sends trap messages approximately every 30 seconds until multicast storm
control recovers.
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 375