Reference Guide

Default None
Format storm-control unicast action {shutdown | trap}
Mode
•
Global Config
•
Interface Config
no storm-control unicast action
This command returns the unicast storm recovery action option to the default value for all interfaces
(Global Config mode) or one or more interfaces (Interface Config mode).
Format no storm-control unicast action
Mode
•
Global Config
•
Interface Config
storm-control unicast level
This command configures the unicast storm recovery threshold for all interfaces (Global Config mode)
or one or more interfaces (Interface Config mode) as a percentage of link speed, and enables unicast
storm recovery. If the mode is enabled, unicast storm recovery is active, and if the rate of unknown L2
unicast (destination lookup failure) trac ingressing on an interface increases beyond the configured
threshold, the trac will be dropped. Therefore, the rate of unknown unicast trac will be limited to the
configured threshold.This command also enables unicast storm recovery mode for an interface.
Default
5
Format storm-control unicast level 0-100
Mode
•
Global Config
•
Interface Config
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for all interfaces (Global
Config mode) or one or more interfaces (Interface Config mode) and disables unicast storm recovery.
Format
no storm-control unicast level
Mode
•
Global Config
•
Interface Config
storm-control unicast rate
Use this command to configure the unicast storm recovery threshold for all interfaces (Global Config
mode) or one or more interfaces (Interface Config mode) in packets per second. If the mode is enabled,
unicast storm recovery is active, and if the rate of L2 broadcast trac ingressing on an interface
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 378