Reference Guide

Broadcast Storm Control Action................. None
Multicast Storm Control Mode................... Disable
Multicast Storm Control Level.................. 5 percent
Multicast Storm Control Action................. None
Unicast Storm Control Mode..................... Disable
Unicast Storm Control Level.................... 5 percent
Unicast Storm Control Action................... None
The following example shows CLI display output for the command.
(Extreme 220) (Routing) #show storm-control 1/0/1
Bcast Bcast Bcast Mcast Mcast Mcast Ucast Ucast Ucast
Intf Mode Level Action Mode Level Action Mode Level Action
------ ------- -------- ---------- ------- -------- ---------- ------- -------- ----------
1/0/1 Disable 5% None Disable 5% None Disable 5% None
The following shows an example of part of the CLI display output for the command.
(Extreme 220) (Routing) #show storm-control all
Bcast Bcast Bcast Mcast Mcast Mcast Ucast Ucast Ucast
Intf Mode Level Action Mode Level Action Mode Level Action
------ ------- -------- ---------- ------- -------- ---------- -------
-------- ----------
1/0/1 Enable 50 Trap Disable 5% None Disable 5% None
1/0/2 Enable 50 Trap Disable 5% None Disable 5% None
1/0/3 Enable 50 Trap Disable 5% None Disable 5% None
1/0/4 Enable 50 Trap Disable 5% None Disable 5% None
1/0/5 Enable 50 Trap Disable 5% None Disable 5% None
1/0/6 Enable 50 Trap Disable 5% None Disable 5% None
1/0/7 Enable 50 Trap Disable 5% None Disable 5% None
1/0/8 Enable 50 Trap Disable 5% None Disable 5% None
1/0/9 Enable 50 Trap Disable 5% None Disable 5% None
1/0/10 Enable 50 Trap Disable 5% None Disable 5% None
1/0/11 Enable 50 Trap Disable 5% None Disable 5% None
1/0/12 Enable 50 Trap Disable 5% None Disable 5% None
1/0/13 Enable 50 Trap Disable 5% None Disable 5% None
1/0/14 Enable 50 Trap Disable 5% None Disable 5% None
1/0/15 Enable 50 Trap Disable 5% None Disable 5% None
1/0/16 Enable 50 Trap Disable 5% None Disable 5% None
1/0/17 Enable 50 Trap Disable 5% None Disable 5% None
1/0/18 Enable 50 Trap Disable 5% None Disable 5% None
1/0/19 Enable 50 Trap Disable 5% None Disable 5% None
Link Dependency Commands
The following commands configure link dependency. Link dependency allows the link status of specified
ports to be dependent on the link status of other ports. Consequently, if a port that is depended on by
other ports loses link, the dependent ports are administratively disabled or administratively enabled so
that the dependent ports links are brought down or up respectively.
no link state track
This command clears link-dependency options for the selected group identifier.
Format
no link state track group-id
Mode Global Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 380