Reference Guide

Format addportunit/slot/port
Mode Interface Config
deleteport (Interface Config)
This command deletes a port or a range of ports from the port-channel (LAG). The interface is a logical
unit/slot/port number of a configured port-channel (or range of port-channels). Instead of unit/slot/
port, lag lag-intf-num can be used as an alternate way to specify the LAG interface. lag lag-intf-num can
also be used to specify the LAG interface where lag-intf-num is the LAG port number.
Format deleteport unit/slot/port
Mode Interface Config
deleteport (Global Config)
This command deletes all configured ports from the port-channel (LAG). The interface is a logical unit/
slot/port number of a configured port-channel. Instead of unit/slot/port, lag lag-intf-num can be used
as an alternate way to specify the LAG interface. lag lag-intf-num can also be used to specify the LAG
interface where lag-intf-num is the LAG port number.
Format
deleteport {unit/slot/port | all}
Mode Global Config
lacp admin key
Use this command to configure the administrative value of the key for the port-channel. The value range
of key is 0 to 65535.
Default
0x8000
Format lacp admin key key
Mode Interface Config
This command can be used to configure a single interface or a range of interfaces.
Note
This command is applicable only to port-channel interfaces.
no lacp admin key
Use this command to configure the default administrative value of the key for the port-channel.
Format
no lacp admin key
Mode Interface Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 384