Reference Guide

no port lacpmode enable all
This command disables Link Aggregation Control Protocol (LACP) on all ports.
Format no port lacpmode enable all
Mode Global Config
port lacptimeout (Interface Config)
This command sets the timeout on a physical interface or range of interfaces of a particular device type
(actor or partner) to either long or short timeout.
Default long
Format port lacptimeout {actor | partner} {long | short}
Mode Interface Config
no port lacptimeout
This command sets the timeout back to its default value on a physical interface of a particular device
type (actor or partner).
Format
no port lacptimeout {actor | partner}
Mode Interface Config
Note
Both the no portlacptimeout and the no lacp actor admin state commands set the
values back to default, regardless of the command used to configure the ports. Consequently,
both commands will display in show running-config.
port lacptimeout (Global Config)
This command sets the timeout for all interfaces of a particular device type (actor or partner) to either
long or short timeout.
Default
long
Format port lacptimeout {actor | partner} {long | short}
Mode Global Config
no port lacptimeout
This command sets the timeout for all physical interfaces of a particular device type (actor or partner)
back to their default values.
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 393