Reference Guide

The reflector-port is configured at the source switch along with the destination RSPAN VLAN. The
reflector-port forwards the mirrored trac towards the destination switch.
Note
This port must be configured with RSPAN VLAN membership.
Use the destination interface unit/slot/port to specify the interface to receive the monitored trac.
The port mirroring commands add a mirrored port (source port) to a session identified with session-id.
The session-id parameter is an integer value used to identify the session. The maximum number of
sessions which can be configured is L7_MIRRORING_MAX_SESSIONS. Option rx is used to monitor only
ingress packets. Option tx is used to monitor only egress packets. If no option is specified, both ingress
and egress packets, RX and TX, are monitored.
A VLAN can also be configured as the source to a session (all the member ports of that VLAN are
monitored).
Note
If an interface participates in some VLAN and is a LAG member, this VLAN cannot be assigned
as a source VLAN for a Monitor session. At the same time, if an interface participates in some
VLAN and this VLAN is assigned as a source VLAN for a Monitor session, the interface can be
assigned as a LAG member.
Remote port mirroring is configured by giving the RSPAN VLAN ID. At the source switch the destination
is configured as RSPAN VLAN and at the destination switch the source is configured as RSPAN VLAN.
Note
On the intermediate switch: RSPAN VLAN should be created, the ports connected towards
Source and Destination switch should have the RSPAN VLAN participation. RSPAN VLAN
egress tagging should be enabled on the interface on the intermediate switch connected
towards the Destination switch.
Default None
Format monitor session session-id destination {interface unit/slot/
port |remote vlan vlan-id reflector-port unit/slot/port}
Mode Global Config
no monitor session destination
This command removes the specified probe port from the selected port mirroring session.
Format
no monitor session session-id destination {interface unit/
slot/port |remote vlan vlan-id reflector-port unit/slot/port}
Mode Global Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 404