Reference Guide

monitor session filter
This command attaches an IP/MAC ACL (Access Control List) to a selected monitor session. This
command configures a probe port and a monitored port for monitor session (port monitoring).
An IP/MAC ACL can be attached to a session by giving the access list number/name.
Use the filter parameter to filter a specified access group either by IP address or MAC address.
The port mirroring commands add a mirrored port (source port) to a session identified with session-id.
The session-id parameter is an integer value used to identify the session. The maximum number of
sessions which can be configured is L7_MIRRORING_MAX_SESSIONS.
Remote port mirroring is configured by giving the RSPAN VLAN ID. At the source switch the destination
is configured as RSPAN VLAN and at the destination switch the source is configured as RSPAN VLAN.
Note
Source and destination cannot be configured as remote on the same device.
Note
IP/MAC ACL can be attached to a session by giving the access list number/name. On the
platforms that do not support both IP and MAC ACLs to be assigned on the same Monitor
session, an error message is thrown when user tries to configure ACLs of both types.
Default None
Format monitor session session-id filter {ip access-group acl-id/
aclname | mac access-group acl-name}
Mode Global Config
no monitor session filter
This command removes the specified IP/MAC ACL from the selected monitoring session.
Format
no smonitor session session-id filter {ip access-group | mac
access-group }
Mode Global Config
monitor session mode
This command enables the selected port mirroring session. This command configures a probe port and
a monitored port for monitor session (port monitoring).
A VLAN can be configured as the source to a session (all member ports of that VLAN are monitored).
Remote port mirroring is configured by adding the RSPAN VLAN ID. At the source switch, the
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 405