Reference Guide

Column Meaning
byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, that is, byte 0 should have the
following mask 'xxxx xx10'. The MAC address used by this bridge when it must be
referred to in a unique fashion. We recommend that this be the numerically smallest
MAC address of all ports that belong to this bridge. However it is only required to be
unique. When concatenated with dot1dStpPriority a unique Bridge Identifier is formed
which is used in the Spanning Tree Protocol.
MAC Address Type The MAC address which should be used for in-band connectivity. The choices are the
burned in or the Locally Administered address. The factory default is to use the burned
in MAC address.
Configured IPv4 Protocol The IPv4 network protocol being used. The options are bootp | dhcp | none.
Configured IPv6 Protocol The IPv6 network protocol being used. The options are dhcp | none.
DHCPv6 Client DUID The DHCPv6 client’s unique client identifier. This row is displayed only when the
configured IPv6 protocol is dhcp.
IPv6 Autoconfig Mode Whether IPv6 Stateless address autoconfiguration is enabled or disabled.
DHCP Client Identifier The client identifier is displayed in the output of the command only if DHCP is enabled
with the client-id option on the network port. See network protocol dhcp on
page 39.
The following example shows CLI display output for the network port.
(admin) #show network
Interface Status............................... Up
IP Address..................................... 10.250.3.1
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.250.3.3
IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................ fe80::210:18ff:fe82:64c/64
IPv6 Prefix is ................................ 2003::1/128
IPv6 Default Router is ........................ fe80::204:76ff:fe73:423a
Burned In MAC Address.......................... 00:10:18:82:06:4C
Locally Administered MAC address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Configured IPv4 Protocol ...................... None
Configured IPv6 Protocol ...................... DHCP
DHCPv6 Client DUID ............................ 00:03:00:06:00:10:18:82:06:4C
IPv6 Autoconfig Mode........................... Disabled
Management VLAN ID............................. 1
DHCP Client Identifier......................... 0fastpath-0010.1882.160B-vl1
show serviceport
This command displays service port configuration information.
Format
show serviceport
Mode
•
Privileged EXEC
•
User EXEC
Column Meaning
Interface Status The network interface status. It is always considered to be up.
IP Address The IP address of the interface. The factory default value is 0.0.0.0.
Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 42