Reference Guide

ip verify binding
Use this command to configure static IP source guard (IPSG) entries.
Format ip verify binding mac-address vlan vlan id ip address
interface interface id
Mode Global Config
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
Format no ip verify binding mac-address vlan vlan id ip address
interface interface id
Mode Global Config
ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come on an interface or
range of interfaces. By default, rate limiting is disabled. When enabled, the rate can range from 0 to 300
packets per second. The burst level range is 1 to 15 seconds.
Default
Disabled (no limit)
Format ip dhcp snooping limit {rate pps [burst interval seconds]}
Mode Interface Config
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the burst level, to
the defaults.
Format
no ip dhcp snooping limit
Mode Interface Config
ip dhcp snooping log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP Snooping application.
This command can be used to configure a single interface or a range of interfaces.
Default
Disabled
Format ip dhcp snooping log-invalid
Mode Interface Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 425