Reference Guide

same layer 2 LAN port but were still interested in receiving multicast trac directed to that group. Also,
fast-leave processing is supported only with IGMP version 2 hosts.
Default Disabled
Format set igmp fast-leave [vlan_id]
Mode Interface Config
Interface Range
VLAN Config
no set igmp fast-leave
This command disables IGMP Snooping fast-leave admin mode on a selected interface.
Format no set igmp fast-leave [vlan_id]
Mode Interface Config
Interface Range
VLAN Config
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN, one interface, a range of
interfaces, or all interfaces. The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a particular interface before deleting the interface
from the entry. This value must be greater than the IGMPv3 Maximum Response time value. The range is
2 to 3600 seconds.
Default
260 seconds
Format set igmp groupmembership-interval [vlan_id] 2-3600
Mode
•
Interface Config
•
Global Config
•
VLAN Config
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format
no set igmp groupmembership-interval [vlan_id]
Mode
•
Interface Config
•
Global Config
•
VLAN Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 434