Reference Guide

set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, on a particular interface or
VLAN, or on a range of interfaces. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for a particular
group in that interface. This value must be less than the IGMP Query Interval time value. The range is 1 to
25 seconds.
Default 10 seconds
Format set igmp maxresponse [vlan_id] 1-25
Mode
•
Global Config
•
Interface Config
•
VLAN Config
no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
Format no set igmp maxresponse [vlan_id]
Mode
•
Global Config
•
Interface Config
•
VLAN Config
set igmp mcrtrexpiretime
This command sets the Multicast Router Present Expiration time. The time is set for the system, on a
particular interface or VLAN, or on a range of interfaces. This is the amount of time in seconds that a
switch waits for a query to be received on an interface before the interface is removed from the list of
interfaces with multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates an
infinite time-out, that is, no expiration.
Default
0
Format set igmp mcrtrexpiretime [vlan_id] 0-3600
Mode
•
Global Config
•
Interface Config
•
VLAN Config
no set igmp mcrtrexpiretime
This command sets the Multicast Router Present Expiration time to 0. The time is set for the system, on
a particular interface or a VLAN.
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 435