Reference Guide

forwarding table entry upon receiving and MLD done message for that multicast group without first
sending out MAC-based general queries to the interface.
Note
You should enable fast-leave admin mode only on VLANs where only one host is connected
to each Layer 2 LAN port. This prevents the inadvertent dropping of the other hosts that were
connected to the same layer 2 LAN port but were still interested in receiving multicast trac
directed to that group.
Note
Fast-leave processing is supported only with MLD version 1 hosts.
Default disabled
Format set mld fast-leave vlanid
Mode
•
Interface Config
•
VLAN Mode
no set mld fast-leave
Use this command to disable MLD Snooping fast-leave admin mode on a selected interface.
Format
no set mld fast-leave vlanid
Mode
•
Interface Config
•
VLAN Mode
set mld groupmembership-interval
Use this command to set the MLD Group Membership Interval time on a VLAN, one interface or all
interfaces. The Group Membership Interval time is the amount of time in seconds that a switch waits for
a report from a particular group on a particular interface before deleting the interface from the entry.
This value must be greater than the MLDv2 Maximum Response time value. The range is 2 to 3600
seconds.
Default
260 seconds
Format set mld groupmembership-interval vlanid 2-3600
Mode
•
Interface Config
•
Global Config
•
VLAN Mode
no set groupmembership-interval
Use this command to set the MLDv2 Group Membership Interval time to the default value.
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 445