Reference Guide

Format no set mld groupmembership-interval
Mode
•
Interface Config
•
Global Config
•
VLAN Mode
set mld maxresponse
Use this command to set the MLD Maximum Response time for the system, on a particular interface or
VLAN. The Maximum Response time is the amount of time in seconds that a switch will wait after
sending a query on an interface because it did not receive a report for a particular group in that
interface. This value must be less than the MLD Query Interval time value. The range is 1 to 65 seconds.
Default 10 seconds
Format set mld maxresponse 1-65
Mode
•
Global Config
•
Interface Config
•
VLAN Mode
no set mld maxresponse
Use this command to set the max response time (on the interface or VLAN) to the default value.
Format
no set mld maxresponse
Mode
•
Global Config
•
Interface Config
•
VLAN Mode
set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time. The time is set for the system, on
a particular interface or VLAN. This is the amount of time in seconds that a switch waits for a query to
be received on an interface before the interface is removed from the list of interfaces with multicast
routers attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite timeout, that is, no
expiration.
Default
0
Format set mld mcrtexpiretime vlanid 0-3600
Mode
•
Global Config
•
Interface Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 446