Reference Guide

set mld querier query_interval
Use this command to set the MLD Querier Query Interval time. It is the amount of time in seconds that
the switch waits before sending another general query.
Default 60 seconds
Format set mld querier query_interval 1-1800
Mode Global Config
no set mld querier query_interval
Use this command to set the MLD Querier Query Interval time to its default value.
Format no set mld querier query_interval
Mode Global Config
set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period. It is the time period that the switch
remains in Non-Querier mode once it has discovered that there is a Multicast Querier in the network.
Default
60 seconds
Format set mld querier timer expiry 60-300
Mode Global Config
no set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period to its default value.
Format
no set mld querier timer expiry
Mode Global Config
set mld querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process when it
discovers the presence of another Querier in the VLAN. When this mode is enabled, if the Snooping
Querier finds that the other Querier’s source address is better (less) than the Snooping Querier’s
address, it stops sending periodic queries. If the Snooping Querier wins the election, then it will continue
sending periodic queries.
Default
disabled
Format set mld querier election participate
Mode VLAN Config
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 452