Reference Guide

20 0/28 00:00:00:00:00:11
20 0/28 00:00:00:00:00:12
20 0/28 00:00:00:00:00:13
(Extreme 220) (Routing) #show mac-address-table limit 10
Vlan MAC Locking Administration Mode: Enabled
For Vlan 10
Configured mac limit 3
Operational mac limit 3
vlan Interface Mac-Address
------- --------- -----------------
10 0/2 00:00:00:00:44:44
10 0/2 00:00:00:00:44:45
10 0/2 00:00:00:00:44:46
LLDP (802.1AB) Commands
This section describes the command used to configure LLDP (Link Layer Discovery Protocol), which is
defined in the IEEE 802.1AB specification. LLDP allows stations on an 802 LAN to advertise major
capabilities and physical descriptions. The advertisements allow a network management system (NMS)
to access and display this information.
lldp transmit
Use this command to enable the LLDP advertise capability on an interface or a range of interfaces.
Default
Disabled
Format lldp transmit
Mode Interface Config
no lldp transmit
Use this command to return the local data transmission capability to the default.
Format
no lldp transmit
Mode Interface Config
lldp receive
Use this command to enable the LLDP receive capability on an interface or a range of interfaces.
Default
Disabled
Format lldp receive
Mode Interface Config
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 460