Reference Guide

Format no lldp receive
Mode Interface Config
lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled for LLDP.
The interval-seconds determines the number of seconds to wait between transmitting local data
LLDPDUs. The range is 1-32768 seconds. The hold-value is the multiplier on the transmit interval that
sets the TTL in local data LLDPDUs. The multiplier range is 2-10. The reinit-seconds is the delay before
reinitialization, and the range is 1-0 seconds.
Default
•
interval—30 seconds
•
hold—4
•
reinit—2 seconds
Format lldp timers [interval interval-seconds] [hold hold-value]
[reinit reinit-seconds]
Mode Global Config
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports enabled
for LLDP to the default values.
Format
no lldp timers [interval] [hold] [reinit]
Mode Global Config
lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs from an interface or range of interfaces. Use sys-name
to transmit the system name TLV. To configure the system name, see snmp-server on page 92. Use sys-
desc to transmit the system description TLV. Use sys-cap to transmit the system capabilities TLV. Use
port-desc to transmit the port description TLV. To configure the port description, see description on
page 279
Default
no optional TLVs are included
Format lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without
parameters to remove all optional TLVs from the LLDPDU.
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 461