Reference Guide

(Extreme 220) #show isdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge,
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Intf Holdtime Capability Platform Port ID
-------------------- ----- --------- ------------ -------------------- --------------------
Switch 0/1 165 RI cisco WS-C4948 GigabitEthernet1/1
The following example shows CLI display output for the command.
(Extreme 220) #show isdp neighbors detail
Device ID 0001f45f1bc0
Address(es):
IP Address: 10.27.7.57
Capability Router Trans Bridge Switch IGMP
Platform SecureStack C2
Interface 0/48
Port ID ge.3.14
Holdtime 131
Advertisement Version 2
Entry last changed time 0 days 00:01:59
Version: 05.00.56
show isdp trac
This command displays ISDP statistics.
Format
show isdp traffic
Mode Privileged EXEC
Term Definition
ISDP Packets Received
Total number of ISDP packets received
ISDP Packets Transmitted
Total number of ISDP packets transmitted
ISDPv1 Packets Received
Total number of ISDPv1 packets received
ISDPv1 Packets Transmitted
Total number of ISDPv1 packets transmitted
ISDPv2 Packets Received
Total number of ISDPv2 packets received
ISDPv2 Packets Transmitted
Total number of ISDPv2 packets transmitted
ISDP Bad Header
Number of packets received with a bad header
ISDP Checksum Error
Number of packets received with a checksum error
ISDP Transmission Failure
Number of packets which failed to transmit
ISDP Invalid Format
Number of invalid packets received
ISDP Table Full
Number of times a neighbor entry was not added to the table due to a full
database
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 491